Lucerna is not a mere redesigned version of the traditional lamppost, but a new project where great care has been taken over the reshaping of a traditional pattern down to the most minute detail. The lantern comes in two versions, respectively with a square and a circular section, paired with redesigned poles in matching styles that are decorated with distinctive floral motifs at the base or around the connector joining the pole to the lamp.
Housing, lid, spokes, and connection for die-cast aluminium pressed poles.
Diffuseur: Tempered glass, 5 mm thick, withstands thermal shock and impacts
Coating: the standard liquid immersion coating consists of a first metal surface pre-treatment stage, a successive epoxy cataphoresis corrosion and salt resistant coating, and a final layer of bi-component acrylic liquid UV-stabilised coating.
Equipment: Stainless steel screws.  Steel slide-away hinge, 25/10 thickness, with safety brackets against the accidental closure of the lid. Supplied with knife switch, which enables to cut off the power supply automatically in case of maintenance. Complete with connector for mains connection and for LED module. Automatic temperature control inside the device with automatic resetting. With dedicated electronic device to protect the LED module. Equipped with an air-circulation valve.
Energy-saving: the possibility to choose the correct drive current for LEDs will allow you to have the right power under specific design conditions, and also help you deal with maintenance and retrofitting problems. Using a lower current will improve the efficiency of fixtures and therefore increase energy savings, whilst a higher current will result in a higher light flux so that you can reduce the number of fixtures.
LED: Power factor >= 0.9.
Luminous flux maintenance 80%: >100.000h (L80B10), Ta-30+40°C.
Photobiological safety class: exempt group. . The total return of the equipment is close to 100%. The total return of the equipment is close to 100%. Each LED module is equipped with a lens with high efficiency
Regulations: Produced according to applicable EN60598-1 CEI 34-21 standards, degree of protection according to EN 60529 standards.
Upon request:
– Coating compliant with UNI EN ISO 9227 Corrosion tests in artificial atmospheres for aggressive environments.
– with power supply 1-10 V dimmable with subcode 12.
– with virtual midnight subcode 30.
– power line carrier remote control systems subcode 0078.
– possibility to control each individual light point

Show less...