Standard supply: Automatic temperature control inside the device with automatic resetting.  Electronic safety device to protect the LED module and the related ballast compliant with EN 61547.
It works in two modes:
– differential mode: surge between power cables and between the phase and neutral.
– common mode: surge between power, L/N and ground cables or between the fixture’s body if it is of class II and installed on a metal pole.
Upon request: protection up to 10KV.
Equipment: complete with IP67 airtight connector for mains connection. Supplied with double insulation switch that cuts off electricity when the cover is opened.
Energy-saving: the possibility to choose the correct drive current for LEDs will allow you to have the right power under specific design conditions, and also help you deal with maintenance and retrofitting problems. Using a lower current will improve the efficiency of fixtures and therefore increase energy savings, whilst a higher current will result in a higher light flux so that you can reduce the number of fixtures.
Optics: in PMMA, highly resistant to temperature and UV radiation.
LED: Ta-30+40°C life 80%: >100.000h (L80B10).
Power factor >0.9
Regulations:Produced according to applicable EN60598-1 CEI 34-21 standards, degree of protection according to EN 60529 standards.
Upon request:
– with power supply 1-10 V dimmable with subcode 12.
– with power supply DIG dimmable with subcode 0041.
– with virtual midnight subcode 30.
– power line carrier remote control systems subcode 0078.
– Nema Socket,
subcode 40
– Zhaga Socket, subcode 0054
– Coating compliant with UNI EN ISO 9227 Corrosion tests in artificial atmospheres for aggressive environments.
Wind surface: L:139cm² F:400cm².

Show less...